Battery replacement

Replace batteries with two new, D cell, alkaline batteries. If replacement batteries are weak and have a battery level of 40% or lower, the LOW BATTERY screen will continue to be displayed at start up.

Note: Do not use rechargeable batteries.
Tools required:
  • Flat head screwdriver
Component damage.

Replace with two, D cell, alkaline batteries only. Always use two new equal batteries, of the same current rating and manufacturer.

  1. Remove the battery access cover by loosening the screw using a flat head screwdriver. The screw will remain in the battery access cover.


      Description Qty.
    1 Console 1
    2 Screw 1
    3 Battery access cover 1
    4 Console cable 1
    • The battery access cover screw will remain in the battery access cover.
    • The battery access cover will remain on the console cable.
  2. Remove the two batteries from the console.


      Description Qty.
    1 Console 1
    2 Batteries 2
  3. Note: The batteries must be installed in the proper direction.
    Install two, D cell, alkaline batteries as shown.
  4. Insert the two battery access cover tabs into console.


      Description Qty.
    1 Console 1
    2 Battery access cover 1
    3 Tabs 2
  5. Tighten the battery access cover screw using a flat head screwdriver.
Note: Dispose of batteries safely after replacement or before unit disposal.