Testing Operation

Use the following instructions to test the full resistance and incline range of the unit:

  1. Grasp handle on incline lever and depress the plunger.


      Description Qty.
    1 Plunger 1
    2 Handle 1
    3 Incline lever 1
  2. Move incline lever to back position.
  3. Release plunger on incline lever.
    To avoid injury, be sure detent pin is fully inserted into notch in adjusting plate before use.


      Description Qty.
    1 Adjusting plate 1
    2 Detent pin 1
    3 Notch 3
  4. Move the resistance lever down to lowest resistance.
  5. Verify foot plates are completely stopped.
  6. Hold the handrails to steady self while stepping into the foot plates.
  7. Begin striding.
  8. Verify the control panel will illuminate.
  9. Press the GO/Enter key.
  10. Verify level meter is at LEVEL 1 and resistance is low.
  11. Verify WATTS are displayed on display screen.
  12. Move the resistance lever up to LEVEL 5.
    Verify resistance is higher than LEVEL 1.
  13. Move the resistance lever up to LEVEL 10.
    Verify resistance is higher than LEVEL 5.
  14. Move the resistance lever down to LEVEL 1.
  15. Press the STOP/Review key to exit.
  16. Wait until foot plates come to a complete stop before dismounting unit.
    Moving parts and fall hazard.
    • To avoid serious injury wait until foot plates come to a complete stop before getting off unit.
    • The moving parts cannot be stopped immediately, the unit is not equipped with a free wheel.

    Hold handrails to steady self while stepping off unit.

  17. Move incline lever to middle position.
  18. Move incline lever to forward position.
  19. Move incline lever to back position.
Testing complete.